Help Rebuild Town Hall

Notice to Contractors & Suppliers

 

Job Drive:Whitman Renderings:Provincetown:Provincetown Rendering - medium.jpg

The Town Manager and Board of Selectmen invite and encourage the participation of Provincetown based Contractors and residents in the Phase II: Comprehensive Restoration and Renovation of the Provincetown Town Hall. Plans and specifications will be available for viewing at the Community Development Office at the temporary town hall for use in the building and electronically for distribution at Projectdog, 18 Graf Road, Suite #8, Newburyport, MA 01950, Tel: (978) 499-9014, Fax: 978-499-9016. Registration and receipt of electronic documents through Projectdog is free.

 

The project follows the Commonwealth of Massachusetts public procurement statutes. Not all sub-contractors need to be DCAM (Dept. of Capital Asset Management) certified. There are many opportunities for local subcontractors and construction material suppliers. A list of registered plan holders will be available at the Town Hall and at the Projectdog website: www.Projectdog.com for registered users. Interested local contractors may post their contact information on the Town of Provincetown website: www.provincetown-ma.gov/THRebuild/interest_form.html.

 

Subcontractors for the following specialties are needed: Selective Demolition, Site Preparation, Earthwork, Paving & Curbing, Fencing & Gates, Lawns, Cast-in-Place Concrete, Structural Steel, Rough Carpentry, Finish Carpentry, Building Insulation, Fire Stopping, Doors/Frames & Hardware, Gypsum Wallboard & Veneer Plaster, Tile, Refinishing of Existing Wood Floor, Resilient Flooring, Carpet, Toilet Partitions, Toilet Accessories and Sprinklers.

 

Subcontractors may post their contact information and specialty on the Town website and/or directly contact registered DCAM-Certified Historic General Contractors who are plan holders. Lodging facilities may also post their interest in providing contractor lodging on this website. The following subcontracts require DCAM certification: Lathing & Plastering, Painting, Plumbing, HVAC and Electrical Work. See Public Notice.